1. Open the Marks option by clicking Print Tab > Print Setup > Marks.
2. Select the Marks you want to use by selecting the appropriate options.
3. If you want to use the Print Label, enable that option and click Setup. This opens the Print Label Setup dialog (Figure 2).
4. Select your options for the Print Label, and click OK.

 

1. Open the Advanced Quick Set Options by clicking Edit Quick Sets > Edit > Advanced > Marks tab.
2. Mark the types of marks you want to use by selecting the appropriate options.
3. If you are using the Print Label, enable that option and click Setup. This opens the Print Label Setup dialog (Figure 2).
4. Select your options for the Print Label, and click OK.

 

Registration marks print a crosshair mark at each corner of an image. These marks help ensure that the image is straight on each side when trimming.

Tile Dotted Overlap marks are used when tiling images with an overlap. These marks show where the overlap begins and ends to help you combine tiles easily. When piecing the tiles together, the Tile Dotted Overlap Mark of one tile overlays the corresponding mark on the adjacent tile.

 

To use Tile Dotted Overlap marks, you must first enable Registration marks. You can then select which sides of the image should have the Tile Dotted Overlap marks.

Crop marks are right-angle marks that are placed on the edges of each corner of the image. Because the same area is used for Registration marks, Crop marks do not have any effect if you are already using Registration marks.

Crop Outline prints a solid line around the border of the entire image. When using Crop Outline, the Crop marks have no effect because the solid line is printed in the same area as the Crop marks.

Zero-line Tile marks print a black crosshair with a white inner portion in the middle of the tile overlap area. These marks show the center point of each tile, allowing you to accurately place the tiles.

The Print Label prints job information at the end of the printed image.

 

To use the Print label, enable the Print Label checkbox, and click Setup. You can then select the type of information you want to include in your Print Label by scanning through and marking the appropriate options.

 

Select the Use Large Text checkbox to print the label using a 22.5 pt. font instead of the default 7.5 pt.

The Contour Cut Path options are only used when using a contour cutting device. You can select the following options:

• Generate Tile Outline Cut Path - This option generates a cut path around the outside edge of each tile.
• Trim Overlap - This option generates a cut path on the Zero-line Tile mark if your tiled image is using an overlap.

 

NOTE: If you do not have a contour cutting device, this option will not work.